Pinpoint Test Al: The Parking Brake Warning Chime Is Inoperative
- AL1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- Place the ignition in the ACC mode.
- Open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
- Yes
: GO to AL2.
- No
: INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- AL2 CHECK THE BRAKE WARNING INDICATOR FOR CORRECT OPERATION
- Ignition ON.
- Apply and release the parking brake.
- Does the brake warning indicator turn on when applied and turn off when released?
- Yes
: GO to AL3.
- No
: GO to PINPOINT TEST J (never on) or GO to PINPOINT TEST K (always on).
- AL3 CHECK THE SPEEDOMETER FOR CORRECT OPERATION
- Ignition ON.
- Drive the vehicle and verify that the speedometer is operating correctly.
- Does the speedometer operate correctly?
- Yes
: GO to AL4.
- No
: GO to PINPOINT TEST E .
- AL4 RETRIEVE THE RECORDED DTCs FROM THE SJB SELF-TEST
- Check for recorded DTCs from the SJB self-test.
- Are any DTCs recorded?
- Yes
: REFER to
MULTIFUNCTION ELECTRONIC MODULES
.
- No
: INSTALL a new SJB. REFER to
SUPPLEMENTAL RESTRAINT SYSTEM
. TEST the system for normal operation.