Pinpoint Test Bk: DTC U0233:00

BK1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?
  - Yes : GO to BK2.
  - No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
BK2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the SOD-R pass the network test?
  - Yes : GO to BK3.
  - No : REFER to MODULE COMMUNICATIONS NETWORK .
BK3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?
  - Yes : GO to PINPOINT TEST BE (U3003:16) or GO to PINPOINT TEST BF (U3003:17).
  - No : GO to BK4.
BK4 RECHECK THE IPC DTCs
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.
- Clear the DTCs. Repeat the IPC self-test.
- Is DTC U0233:00 still present?
  - Yes : INSTALL a new SOD-R. REFER to SIDE AND REAR VISION . CLEAR the DTCs. REPEAT the IPC self-test.
    If DTC U0233:00 is still present, INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
  - No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.