Instrument Cluster Finish Panel - Expedition

Fig 1: Exploded View Of Instrument Cluster Finish Panel Components - Expedition

Courtesy of FORD MOTOR CO.

ITEM DESCRIPTION CHART

Item	Part Number	Description
1	W707628	Steering column opening trim panel screws (3 required)
2	04459	Steering column opening trim panel
3	-	Instrument cluster finish panel bridge
4	W707628	Instrument cluster finish panel screw (2 required)
5	04320	Instrument cluster finish panel

Column shift vehicles only

Place the selector lever to the 1 position.
All vehicles
Remove the steering column opening trim panel.
- Remove the 3 steering column opening trim panel screws.
- Release the steering column opening trim panel from the instrument panel.
  
  Fig 2: Locating Steering Column Opening Trim Panel Screws
  Courtesy of FORD MOTOR CO.
Tilt the steering wheel to the full down position.
Remove the instrument cluster finish panel bridge.
- Pull upward and then left on the LH side of the finish panel bridge to release the retainer and remove the finish panel bridge.
Remove the 2 instrument cluster finish panel screws.
Remove the instrument cluster finish panel.
- Pull on the finish panel to release it from the retainers.
- Disconnect the electrical connectors.
To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.