Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Installation of new sun visor gaskets is necessary when the sun visor has been removed.

Remove and discard the screws.
- To install, tighten to 4 N.m (35 lb-in).

Fig 1: Removing Screws

Courtesy of FORD MOTOR CO.

CAUTION: The sun visor gasket adhesive is extremely strong. Make sure to use adequate amount of force to remove the sun visor from the vehicle.

Remove the sun visor from the vehicle, then disconnect the electrical connector.

Fig 2: Locating Sun Visor

Courtesy of FORD MOTOR CO.

Remove and discard the sun visor gasket.

Fig 3: Locating Sun Visor Gasket

Courtesy of FORD MOTOR CO.

CAUTION: If removing a rear rivet nut, removal of the headliner is necessary. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.

NOTE: If the hole is out of specification, refer to Specifications in this article.

If installing a new sun visor retaining screw or rivet nut, grind or drill the screw head and rivet nut flush.

Fig 4: Drilling Screw Head

Courtesy of FORD MOTOR CO.

Punch the remaining rivet nut through the hole.

Fig 5: Drilling Screw Head And Rivet Nut Flush

Courtesy of FORD MOTOR CO.

Install a new rivet nut.

NOTE: Installation of a new sun visor gasket is necessary when the sun visor has been removed.

NOTE: Prior to installation, clean the sun visor and roof panel mating surfaces.

NOTE: Make sure to wrap the electrical connector with anti-rattle tape before installing the sun visor.

To install, reverse the removal procedure.