Removal and Installation
NOTE:
Non-Hybrid shown in the illustration, Hybrid similar.
ITEM DESCRIPTION
| Item | Part Number | Description |
|---|---|---|
| 1 | 10849 | Instrument Panel Cluster (IPC) |
| 2 | 10890 | IPC lens and mask assembly (Fusion and Milan) |
| 2 | 10B885 | IPC lens (MKZ) |
| 3 | - | Screw (1 required, non-hybrid) (4 required, hybrid) |
All vehicles
- Remove the Instrument Panel Cluster (IPC
). For additional information, REFER to INSTRUMENT PANEL CLUSTER (IPC) in this service information.
Fusion and Milan
NOTE: Make sure the screw(s) are securely tightened, but do not over-tighten to prevent stripping the screw out.NOTE: While the IPC lens is removed, the IPC must remain with the gauges facing upward to maintain gauge calibration. - Remove the screw (non-hybrid) or the 4 screws (hybrid).
- Release the 6 tabs (non-hybrid) or 8 tabs (hybrid) and remove the lens and mask assembly.
MKZ
- Release the 8 tabs and remove the lens.
All vehicles
- To install, reverse the removal procedure.