Pinpoint Test G: A Single Illumination Source Is Inoperative - Door Lock Control Switches

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

G1 CHECK CIRCUIT 194 (PK) FOR VOLTAGE
- Disconnect: Suspect door lock control switch.
- Key in ON position.
- Measure the voltage between the driver door lock control switch C605-5,, or the passenger door lock control switch C605-5, circuit 194 (PK), harness side and ground.
  
  Fig 1: Checking Circuit 194 (PK) For Voltage
  Courtesy of FORD MOTOR CO.
- Is the voltage greater than 10 volts?
Yes : GO to G2.

No : VERIFY that central junction box (CJB) fuse 17 (15A) is OK. If OK, REPAIR the circuit. TEST the system for normal operation.
G2 CHECK CIRCUIT 57 (BK) FOR AN OPEN
- Key in OFF position.
- Measure the resistance between the driver door lock control switch CL C505-1, or the passenger door lock control switch C605-1, circuit 57 (BK), harness side and ground.
  
  Fig 2: Checking Circuit 57 (BK) For Open
  Courtesy of FORD MOTOR CO.
- Is the resistance less than 5 ohms?
Yes : INSTALL a new door lock control switch. REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS . TEST the system for normal operation.

No : REPAIR the circuit. TEST the system for normal operation.