LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2011 >> MKS EcoBoost >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Accessory Drive System >> Removal And Installation >> Accessory Drive Belt Tensioner - 3.5L GTDI >> Installation

Accessory Drive Belt Tensioner - 3.5L GTDI: Installation

  1. Install the accessory drive belt tensioner and the 3 bolts.
    • Tighten to 11 Nm (97 lb-in).
  2. Working from under the vehicle, position the accessory drive belt on all pulleys with the exception of the crankshaft pulley.
    3. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
  3. Rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the crankshaft pulley.
  4. Install the RH splash shield and the 7 pin-type retainers.
  5. Install the RH front wheel and tire. For additional information, refer to WHEELS & TIRES article.
scientia non olet · About LEMON Manuals