LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2011 >> MKS EcoBoost >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Removal And Installation >> Instrument Panel Cluster (IPC) >> Installation

Instrument Panel Cluster (IPC): Installation

  1. Position the IPC in the instrument panel, connect the electrical connector and install the 2 screws.
  2. Install the instrument cluster finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  3. If installing a new IPC, download the IPC configuration information from the scan tool into the new IPC. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION SYSTEM article.
    4. NOTE: If installing a new IPC on vehicles that are not equipped with IA, the IPC and the PCM require a parameter reset to allow the IPC and the PCM to recognize each other. Failure to carry out the parameter reset to the IPC and the PCM may result in a no start condition.
  4. If installing a new IPC on vehicles that are not equipped with IA, carry out the parameter reset procedure. For additional information, refer to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) .
    5. NOTE: If equipped, the vehicle's Integrated Keyhead Transmitter (IKT) keys must be programmed to the new IPC.
  5. If installing a new IPC, carry out the PATS key programming. For additional information, refer to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
scientia non olet · About LEMON Manuals