LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2011 >> MKS EcoBoost >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AV: DTC U0151:00 >> Pinpoint Test Av: DTC U0151:00

Pinpoint Test Av: DTC U0151:00

  1. AV1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.
    • Is an observable symptom present? 
      • Yes  : GO to AV2.
      • No  : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. AV2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Carry out the network test.
    • Does the RCM pass the network test? 
  3. AV3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Check for recorded DTCs from the IPC self-test.
    • Is DTC U3003:16 or DTC U3003:17 recorded? 
  4. AV4 RECHECK THE IPC DTCs 
    • Clear the DTCs. Repeat the IPC self-test.
    • Is DTC U0151:00 still present? 
      • Yes  : GO to AV5.
      • No  : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  5. AV5 CHECK FOR DTC U0151 OR DTC U0151:00 SET IN OTHER MODULES 
    • Clear all DTCs.
    • Ignition OFF.
    • Ignition ON.
    • Wait 10 seconds.
    • Enter the following diagnostic mode on the scan tool: Self-Test.
    • Retrieve the continuous memory DTCs from all modules.
    • Is DTC U0151 or DTC U0151:00 set in the Occupant Classification System Module (OCSM)?