Pinpoint Test An: The Parking Brake Warning Chime Is Inoperative

AN1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- On vehicles without Intelligent Access (IA), insert the key into the ignition lock cylinder.
- On vehicles equipped with IA, place the ignition in the ACC mode.
- Open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
  - Yes : GO to AN2.
  - No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
AN2 CHECK THE BRAKE WARNING INDICATOR FOR CORRECT OPERATION
- Ignition ON.
- Apply and release the parking brake.
- Does the brake warning indicator turn on when applied and turn off when released?
  - Yes : GO to AN3.
  - No : GO to PINPOINT TEST L (never on) or GO to PINPOINT TEST M (always on).
AN3 CHECK THE SPEEDOMETER FOR CORRECT OPERATION
- Ignition ON.
- Drive the vehicle and verify that the speedometer is operating correctly.
- Does the speedometer operate correctly?
  - Yes : GO to AN4.
  - No : GO to PINPOINT TEST F .
AN4 RETRIEVE THE RECORDED DTCs FROM THE SJB SELF-TEST
- Check for recorded DTCs from the SJB self-test.
- Are any DTCs recorded?
  - Yes : REFER to MULTIFUNCTION ELECTRONIC MODULES article.
  - No : INSTALL a new SJB. REFER to SUPPLEMENTAL RESTRAINT SYSTEM article. TEST the system for normal operation.