Pinpoint Test Ah: The Check Fuel Fill Inlet Message Is Inoperative/Always On

AH1 CHECK THE MESSAGE CENTER OPERATION
- Close all doors, hood and luggage compartment lid.
- Ignition ON.
- Open the driver door while monitoring the message center displays.
- Does the message center display DRIVER DOOR AJAR?
  - Yes : GO to AH2.
  - No : GO to PINPOINT TEST AD .
AH2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST
- Check for recorded DTCs from the Key ON Engine OFF (KOEO) self-test.
- Is DTC P0457 recorded?
  - Yes : If the CHECK FUEL FILL INLET message is illuminated, REFER to the INTRODUCTION - GASOLINE MODELS article.
    If the CHECK FUEL FILL INLET message is not illuminated, GO to AH3.
  - No : If the CHECK FUEL FILL INLET message is always on, INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
    If the check fuel cap indicator is not illuminated, the system is operating normally at this time. If the fuel cap was left off and the CHECK FUEL FILL INLET message did not turn on, driving conditions may not have allowed for the PCM to run the cruise test and message the IPC to turn the CHECK FUEL FILL INLET message on.
AH3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded IPC DTCs from the self-test.
- Are any DTCs recorded?
  - Yes : For DTC U0100:00, GO to PINPOINT TEST AQ . For all other DTCs, REFER to DIAGNOSTIC TROUBLE CODES (DTC) TABLES .
  - No : INSTALL a new PCM. REFER to ENGINE CONTROLS - ELECTRONIC ENGINE CONTROLS article. TEST the system for normal operation.