Removal and Installation
NOTE:
The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel sliding glass motor or power shade motor has been removed from the roof opening panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION in this service information.
- Place the front sliding glass panel in the full OPEN position.
- Remove the air deflector.
- Remove the 3 screws.
- Remove the air deflector from the roof opening panel frame.
- To install, reverse the removal procedure.
- Initialize the front sliding glass panel motor. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION in this service information.