Removal and Installation

NOTE: Any time a new cushion foam pad is installed, new cushion heater mats must be installed. Any time new cushion heater mats are installed, a new cushion foam pad must be installed. Always install a new cushion foam pad and cushion heater mats together. For additional information, refer to SEAT CUSHION HEATER MAT - REAR .

Remove the rear seat cushion. For additional information, refer to SEAT CUSHION - REAR .
From underneath the cushion assembly, remove the hog rings retaining the cushion trim cover wires and draw strings to the cushion foam pad wires.
- Route the heated seat mat wire harness under the draw string at installation.
  
  Fig 1: Routing Heated Seat Mat Wire Harness Under Draw String At Installation
  Courtesy of FORD MOTOR CO.

NOTE: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from the cushion foam pad.

Remove the hog rings, separate the hook-and-loop strips and remove the cushion trim cover.
To install, reverse the removal procedure.