Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Remove the front lower air deflector. For additional information, refer to the Front Bumper Exploded View in BUMPER SYSTEM article.
- Remove the RH front fender splash shield. For additional information, refer to BODY PANEL SYSTEM - FRONT END BODY PANELS article.
- Disconnect the washer fluid level sensor electrical connector.
- Disconnect the washer pump electrical connector.
- Disconnect the washer pump hose.
- Remove the washer reservoir bolt.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the 2 washer reservoir nuts and the washer reservoir.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the washer reservoir.
- To install, reverse the removal procedure.
- Fill the washer reservoir with windshield washer fluid.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE:
To prevent spilling washer fluid, drain the washer reservoir before removal.
NOTE:
Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature washer pump failure.