Removal and Installation

From under the front of the cushion assembly, push the 2 cushion floor latch release levers toward the driver side, while lifting up and disengage the front of the cushion assembly.

Fig 1: Pushing Cushion Floor Latch Release Levers Toward Driver Side
Courtesy of FORD MOTOR CO.
Remove the cushion assembly in the following sequence.
1. Push the cushion assembly back as far as possible.
2. Lift up and pull out at the rear outboard ends of the cushion assembly, disengaging the cushion assembly wires from the retainer hooks.
3. Pull the cushion assembly forward.
4. Disconnect the heated seat electrical connector.
5. Remove the cushion assembly.
To install, reverse the removal procedure.
- Make sure the safety belt buckles are accessible to the occupants after installation.