Removal and Installation

Push the backrest trim cover and foam pad away and remove the armrest bolt and wave washer.
- To install, tighten to 23 Nm (17 lb-ft).
  
  Fig 1: Locating Armrest Bolt
  Courtesy of FORD MOTOR CO.
Tilt the armrest and slide the armrest stud out of the backrest frame and grommet.

Fig 2: Locating Armrest Stud
Courtesy of FORD MOTOR CO.
Pull up hard and remove the cup holder from the armrest.
Remove 2 screws and the armrest cover.
To install, reverse the removal procedure.