Selector Lever - MKZ: Removal

Remove the selector lever bezel. For additional information, refer to Removal .
Remove the PRNDL electrical connector from the RH side of the center console.

Fig 1: Locating PRNDL Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the LH and RH center console trim covers.
NOTE: LH shown in illustration, RH similar.

Fig 2: Locating Center Console Trim Cover
Courtesy of FORD MOTOR CO.
Remove the LH and RH center console-to-selector lever screws.
NOTE: LH shown in illustration, RH similar.

Fig 3: Locating Center Console-To-Selector Lever Screws
Courtesy of FORD MOTOR CO.
Disconnect the selector lever cable end from the selector lever ball stud.

Fig 4: Locating Selector Lever Cable
Courtesy of FORD MOTOR CO.
Disconnect the selector lever electrical connector.

Fig 5: Locating Selector Lever Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the 4 selector lever nuts.

Fig 6: Locating Selector Lever Nuts
Courtesy of FORD MOTOR CO.
Position the selector lever off of the studs, release the tab on the selector lever cable and remove it from the selector lever.

Fig 7: Positioning Selector Lever Off Of Studs

Courtesy of FORD MOTOR CO.