LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid) >> General Procedures >> Selector Lever - Fusion/Milan >> Removal

Selector Lever - Fusion/Milan: Removal

  1. Remove the center console. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the selector lever cable end from the selector lever.
    Fig 1: Locating Selector Lever Cable
    G06275674Courtesy of FORD MOTOR CO.
  3. Release the tab on the selector lever cable and remove it from the selector lever housing.
    Fig 2: Locating Selector Lever Cable Tab
    G06275675Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    Fig 3: Locating Electrical Connector
    G06275676Courtesy of FORD MOTOR CO.
  5. Remove the 4 nuts and remove the selector lever.
    Fig 4: Locating Selector Lever Nuts
    G06275677Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals