LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ FWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC - Climate Control System >> Removal And Installation >> In-Vehicle Temperature Sensor - MKZ >> Removal and Installation

Removal and Installation

  1. Remove the instrument cluster finish panel. For additional information, refer to REMOVAL AND INSTALLATION (Fusion, Milan) and REMOVAL AND INSTALLATION (MKZ) .
  2. Disconnect the in-vehicle temperature sensor aspirator hose connection at the heater core and evaporator core housing.
  3. Detach the in-vehicle temperature sensor aspirator hose pin-type retainer.
  4. Lower the glove compartment.
  5. Remove the 4 RH instrument panel finish molding screws.
  6. Remove the RH instrument panel finish molding.
  7. Detach the in-vehicle temperature sensor grille from the instrument panel.
  8. Detach the in-vehicle temperature sensor grille from the in-vehicle temperature sensor.
  9. Disconnect the in-vehicle temperature sensor electrical connector.
  10. Remove the in-vehicle temperature sensor and aspirator hose assembly.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals