Pinpoint Test W: The Service Soon Warning Indicator Is Inoperative (Hybrid)

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

W1 CHECK THE RECORDED DTCs FROM BOTH CONTINUOUS AND ON-DEMAND PCM, TBCM, TCM AND POWER STEERING CONTROL MODULE SELF-TESTS
- Check the DTCs from the continuous and on-demand self-tests.
- Are any DTCs recorded?
1. YES : If any PCM DTCs are recorded, REFER to INTRODUCTION -- HYBRID ENGINES article.
  If any other DTCs are recorded, REFER to MULTIFUNCTION ELECTRONIC MODULES article.
2. NO : Go to W2.
W2 CARRY OUT THE INSTRUMENT CLUSTER PROVE-OUT
- Carry out the instrument cluster self-diagnostic test for the bulb check.
- Observe the service soon warning indicator.
- Does the service soon warning indicator illuminate?
1. YES : Go to W4.
2. NO : Go to W3.
W3 CHECK FOR CORRECT INSTRUMENT CLUSTER OPERATION
- Disconnect the instrument cluster connector.
- Check for:
  - corrosion
  - damaged pins
  - pushed-out pins
- Connect the instrument cluster connector and make sure it seats correctly.
- Operate the system and determine if the concern is still present.
- Is the concern still present?
1. YES : INSTALL a new instrument cluster. REFER to Instrument Cluster . TEST the system for normal operation.
2. NO : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
W4 CHECK FOR CORRECT PCM OPERATION
- Disconnect all the PCM connectors.
- Check for:
  - corrosion
  - damaged pins
  - pushed-out pins
- Connect all the PCM connectors and make sure they seat correctly.
- Operate the system and determine if the concern is still present.
- Is the concern still present?
1. YES : INSTALL a new PCM. REFER to ELECTRONIC ENGINE CONTROLS - HYBRID article. TEST the system for normal operation.
2. NO : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.