LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 824 (Safety Belt System - F250-F550) >> Removal And Installation >> Safety Belt Buckle - Front, 40/20/40 Seat, Driver and Passenger >> Removal And Installation >> Driver seat

Driver seat

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the safety belt warning switch electrical connector.
    • Remove the pin-type retainer from the safety belt warning switch electrical connector.
    Fig 1: Locating Safety Belt Warning Switch Electrical Connector
    GF0005408Courtesy of FORD MOTOR CO.
  2. Remove the front inboard track-to-seat pan bolt.
    Fig 2: Locating Front Inboard Track-To-Seat Pan Bolt
    GF0005409Courtesy of FORD MOTOR CO.
  3. Loosen the rear inboard track-to-seat pan bolt to allow the removal of the electrical connector.
  4. Position the electrical connector as shown and remove it through the seat opening.
    Fig 3: Positioning Electrical Connector
    GF0005410Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals