All vehicles
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
- Using a suitable suction device, drain the power steering fluid reservoir.
- Release the clamp and disconnect the power steering fluid return hose.
- Release the clamp and disconnect the power steering fluid supply hose.
- Remove the 2 power steering fluid reservoir bolts.
- Discard the bolts.
- To install, tighten the new bolts to 8 Nm (71 lb-in).
- To install, reverse the removal procedure.
- Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.
NOTE:
The fluid reservoir bolts have a dry adhesive on the threads. The bolts must not be reused.