LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 793 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to the INTRODUCTION - GASOLINE ENGINES article for correct vehicle communication module (VCM) hook-up procedure.
  1. If servicing the powertrain control module (PCM), connect the scan tool to the vehicle. Allow the scan tool to identify the vehicle and obtain configuration data.
    • All programmable module information will automatically be retrieved by the VCM.
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Disconnect the powertrain control module (PCM) electrical connectors.
  4. Remove the 2 bolts and the PCM.
    • To install, tighten to 7 N.m (62 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals