LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 793 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Camshaft Position (CMP) Sensor - 6.8L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the camshaft position (CMP) sensor electrical connector.
  2. Remove the bolt and the CMP sensor.
    • To install, tighten to 10 N.m (89 lb-in).
    • Lubricate the O-ring seal with clean engine oil prior to installation.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals