LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Charging System (Battery, Mounting And Cables)) >> Removal And Installation >> Battery Cables - Frame Mounted, Gasoline >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to Battery Disconnect - Dual .
  2. Remove the battery. For additional information, refer to Battery .
  3. Remove the upper RH battery tray bolt.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Loosen the 3 remaining battery tray bolts.
    • To install, tighten to 40 Nm (30 lb-ft).
  5. Slide the battery tray up and to the right to disengage the battery tray from the 3 battery tray bolts and lower it onto the safety straps.
  6. Remove the 2 nuts and bolts and position the battery tray cover aside.
    • To install, tighten to 7 Nm (62 lb-in).
  7. Loosen the nuts and disconnect the battery terminals.
    • To connect, tighten to 15 Nm (11 lb-ft).
  8. Remove the bolt and position the frame-mounted battery harness-to-frame retainer aside.
    • To install, tighten to 14 Nm (10 lb-ft).
  9. Remove the 8 harness locators from the frame rail.
  10. Remove the starter solenoid terminal cover.
  11. Remove the nut and position the starter solenoid positive cable aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  12. Remove the nut and position the starter solenoid wire terminal aside.
    • To install, tighten to 5 Nm (44 lb-in).
  13. Remove the nut and position the battery ground cable terminal aside.
    • To install, tighten to 23 Nm (17 lb-ft).
  14. Remove the nut and position the battery cable lower bracket aside.
    • If equipped with 4.6L engine, tighten to 15 Nm (11 lb-ft).
    • If equipped with 5.4L or 6.8L engine, tighten to 55 Nm (41 lb-ft).
  15. Separate the transmission cooler line clip from the battery cable lower bracket.
  16. Remove the harness locator from the frame.
  17. Remove the nut and position the battery ground cable eyelet aside.
    • To install, tighten to 8 Nm (71 lb-in).
  18. Remove the nut and position the generator cable and battery junction box (BJB) terminals aside.
    • To install, tighten to 9 Nm (80 lb-in).
  19. Remove the battery cable assembly.
  20. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals