Disassembly And Assembly
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear seat cushion.
- Position the seat cushion forward.
- Release the locking tab and slide the rear seat cushion outward.
- Unzip the cushion cover zipper.
- Invert and remove the cushion cover.
- Remove the 2 bolts and cushion pivot upper link.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the 2 cushion hinge floor bracket bolts and cushion support-to-floor bracket.
- To install, tighten to 40 Nm (30 lb-ft).
- To assemble, reverse the disassembly procedure.
NOTE:
Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat cushion foam pad.