LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 925 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Interior Door Handle - Rear >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door interior trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Position the watershield aside.
  3. Release the interior door handle clip.
    4. Fig 1: Interior Door Handle Clip
    GF0023809Courtesy of FORD MOTOR CO.
  4. Disconnect the interior door handle cable.
    1. Release the cable conduit.
    2. Disconnect the door latch cable.
    5. Fig 2: Interior Door Handle Cable Conduit
    GF0023810Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals