LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 824 (Safety Belt System - F250-F550) >> Removal And Installation >> Safety Belt Retractor - Front, Without Seat Integrated Restraints (SIR) >> Removal And Installation >> Crew Cab vehicles

Crew Cab vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Inspect the D-ring cover for damage. If the cover is damaged or does not remain closed, install a new D-ring cover.
  1. Open the D-ring cover.
  2. Remove the nut and the D-ring.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the bolt and the safety belt retractor anchor.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Remove the front and rear door scuff plates.
  5. Remove the 2 covers, 2 bolts and the B-pillar assist handle.
  6. Remove the B-pillar trim panel.
  7. Remove the bolt and the safety belt retractor.
    • To install, tighten to 40 Nm (30 lb-ft).
scientia non olet · About LEMON Manuals