All seats

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the utility tray, if required.

Remove the bolt and the affected safety belt buckle.
- To install, tighten to 40 Nm (30 lb-ft).
Fig 1: Locating Safety Belt Buckle Bolt
Courtesy of FORD MOTOR CO.

NOTE: Make sure the safety belt webbing is not twisted prior to installation.

To install, reverse the removal procedure.
Check the restraint system for correct operation. For additional information, refer to Safety Belt System in this article.