Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the light sensor and bezel as an assembly.
- Disconnect the electrical connector.
Courtesy of FORD MOTOR CO.
NOTE:
Take care not to break the retaining tabs.
- Disengage the locking tabs and remove the light sensor.
- To install, reverse the removal procedure.