All vehicles
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Disconnect the ABS module electrical connector.
- Remove the 4 screws and the ABS module.
- To install, tighten to 3 Nm (27 lb-in).
- To install, reverse the removal procedure.
- When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for calibration procedures. For additional information on configuration, refer to MODULE CONFIGURATION article.
NOTE:
The ABS module is not repairable. If an internal problem exists, a new part must be installed.