Vehicles equipped with a manual transmission

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Position the engine with the front of the engine facing the LH side of the vehicle. Lower the engine until the generator pulley is slightly higher than the radiator upper support.

Fig 1: Lowering Engine Until Generator Pulley Is Slightly Higher Than Radiator Upper Support
Courtesy of FORD MOTOR CO.
Turn the engine 90 degrees to the right, lower the engine and mate it to the transmission.

Fig 2: Lowering Engine And Mating It To Transmission
Courtesy of FORD MOTOR CO.

Connect the fuel vapor tubes to the purge valve. Position the clutch master cylinder reservoir and install the pushpins.

Fig 1: Connecting Fuel Vapor Tubes To Purge Valve And Positioning Clutch Master Cylinder Reservoir And Installing Push Pins
Courtesy of FORD MOTOR CO.