Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the upper roller hinge trim cover.
1. Remove the screw.
2. Remove the upper roller hinge trim cover.

Fig 1: Upper Roller Hinge Trim Cover & Screw

Courtesy of FORD MOTOR CO.

If equipped, remove the window latches.
1. Remove the 3 window latch screws.
2. Raise the window latch.
3. Remove the window latch from the window.

Fig 2: Window Latch & Screws

Courtesy of FORD MOTOR CO.

Remove the door pull handle.
1. Remove the door pull handle fastener trim covers.
2. Remove the 2 door pull handle screws.
3. Remove the door pull handle.

Fig 3: Door Pull Handle, Fastener Trim Covers & Screws

Courtesy of FORD MOTOR CO.

Remove the sliding door window garnish molding.
- Pry the window garnish molding from the door, starting at the top.

Fig 4: Sliding Door Window Garnish Molding

Courtesy of FORD MOTOR CO.

Remove the sliding door trim panel.
1. Remove the 2 screws.
  - For the lower level trim, remove the 9 door trim panel rivets (not shown).
2. Lift the door trim panel slightly upward and remove.

Fig 5: Sliding Door Trim Panel & Screws

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.