LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1063 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate - Hybrid >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the battery junction box (BJB) fuses 9 (50A) and 18 (50A).
  3. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
    4. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
  4. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
    • Support the caliper using mechanic's wire.
  5. Remove the 2 brake caliper anchor plate bolts.
    • To install, tighten to 175 Nm (129 lb-ft).
  6. Remove the brake caliper anchor plate.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals