Pinpoint Test K: The EV Gauge Is Inoperative (Hybrid)

NOTE: The gas engine must be off with the vehicle operating in electric vehicle mode for the EV gauge to operate.

K1 VERIFY THAT THE IPC IS IN THE CORRECT DISPLAY SETTING
- Ignition ON.
- Using the setup menu, verify that the IPC is in the enlighten display mode.
- Is the IPC in the enlighten display mode?
- Yes : GO to K2.
- No : SET the display setting to enlighten mode.
K2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST
- Check for recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Are any DTCs recorded?
- Yes : DIAGNOSE all PCM DTCs first. REFER to the INTRODUCTION - GASOLINE MODELS and INTRODUCTION -- HYBRID .
- No : GO to K3.
K3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
- Are any DTCs recorded?
- Yes : For DTC U0100:00, Go To PINPOINT TEST BF .
  For DTC U0401:68, RETRIEVE and REPAIR all non-network DTCs in the PCM and other modules on the network. REFER to the INTRODUCTION - GASOLINE MODELS and INTRODUCTION -- HYBRID and MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs.
  
  For all other DTCs, REFER to DTC TABLES .
- No : INSTALL a new IPC . REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.