LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 939 (Hydraulic Brake System Actuation) >> Removal And Installation >> Brake Pedal and Bracket >> Removal And Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
    2. CAUTION: Always remove the stoplamp switch before removing the speed control deactivator switch. Always remove both switches with the brake pedal secured to the brake booster push rod and with the brake pedal in the at-rest position. Do not press or pull on the brake pedal when removing the switches or damage to the switches can occur.
    CAUTION: The stoplamp switch and the speed control deactivator switch must be removed prior to removing the brake pedal and bracket, and the brake booster and associated mounting fasteners or damage to the switches can occur.
  2. Remove the stoplamp switch. For additional information, refer to EXTERIOR LIGHTING .
  3. If equipped, remove the speed control deactivator switch. For additional information, refer to SPEED CONTROL .


  1. Remove the bulkhead sound insulator.
  2. Remove the 2 brake pedal bracket bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
    3. CAUTION: Support the brake master cylinder and power brake booster in the engine compartment.
  3. Remove the 4 brake pedal bracket nuts and remove the brake pedal and bracket.
    • To install, tighten to 25 Nm (18 lb-ft).
    4. CAUTION: Do not install the stoplamp switch and the speed control deactivator switch until installation of the brake booster, and the brake pedal and bracket are complete. The brake pedal arm must be secured to the brake booster push rod and in the at-rest position prior to switch installation. Failure to follow these instructions can result in incorrect adjustment or damage to the switches.
    CAUTION: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch or the speed control deactivator switch. Failure to follow these instructions can result in incorrect adjustment or damage to the switches.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals