Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
- Remove the 2 bolts and position the hood latch release handle aside.
- Remove the 2 bolts and the steering column opening cover.
- Remove the 5 steering column opening cover reinforcement bolts and the reinforcement.
- To install, tighten to 7 Nm (62 lb-in).
- Disconnect the ignition switch electrical connector.
- Remove the 2 ignition switch screws and the ignition switch.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.
- Repower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
NOTE:
The ignition switch should be in the OFF position.