Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Slide the evaporative emission (EVAP) canister purge valve off the bracket.
- Disconnect the intake manifold vapor tube-to-EVAP canister purge valve quick connect coupling, fuel tank vapor tube-to-EVAP canister purge valve quick connect coupling and the EVAP canister purge valve electrical connector. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
- Remove the valve.
- To install, reverse the removal procedure.
- Carry out the leak test. For additional information, refer to Evaporative Emission System Leak Test .
- Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair Verification Drive Cycle .
WARNING:
The evaporative emission (EVAP) system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel is present in the area. Failure to follow these instructions may result in personal injury.