LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Ignition Lock Cylinder - Functional >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Insert the ignition key and turn to the RUN position.
  3. Press the ignition lock cylinder release pin and remove the ignition lock cylinder.
  4. To install, reverse the removal procedure.
    • Verify ignition lock cylinder operation.
scientia non olet · About LEMON Manuals