LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Front Door Latch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Remove the bolt and the door glass channel.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. Disconnect the door lock cylinder actuating rod from the front door latch.
  5. Unclip the exterior door handle actuating rod from the exterior door handle.
  6. Remove the exterior door handle actuating rod.
  7. Remove the 3 front door latch screws.
    • To install, tighten to 12 Nm (9 lb-ft).
  8. Disconnect the door ajar switch electrical connector.
    • If equipped, disconnect the door lock actuator electrical connector.
  9. Position the door latch assembly aside.
  10. Remove the front door latch cable watershield.
  11. Disconnect the front door latch cable.
  12. If necessary, remove the door latch push button rod.
  13. Remove the front door latch.
  14. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals