Pinpoint Test B: Shift Control Is Out Of Correct Gear Relationship
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- B1 CHECK THE SHIFT CONTROL LINKAGE
- Key in ON position.
- Apply the brake pedal.
- Gain access to the shift control linkage.
- Actuate the transmission range selector lever in all ranges.
- Observe all linkages during operation.
- Is the linkage damaged?
- YES : INSTALL a new shift control linkage. TEST the system for normal operation.
- NO : Go to B2.
- B2 CHECK THE TRANSMISSION SELECTOR LEVER CABLE
- Check the transmission selector lever cable and the bracket installation and tightness.
- Is the transmission selector lever cable correctly installed and adjusted?
- YES : VERIFY the transmission selector lever cable adjustment. REFER to Selector Lever Cable Adjustment in this article. ADJUST the transmission selector lever cable if necessary. VERIFY the digital transmission range (TR) sensor for correct adjustment. REFER to AUTOMATIC TRANSMISSION - 5R44E AND 5R55E article. ADJUST the TR sensor if necessary. Go to B3 .
- NO : REPAIR as necessary. TEST the system for normal operation.
- B3 CHECK THE LINKAGE/CABLE FOR CORRECT GEAR RELATIONSHIP
- Apply the brake pedal.
- Actuate the transmission range selector lever in all ranges.
- Does the indicator match the gear selection?
- YES : System OK. TEST the system for normal operation.
- NO : REFER to Selector Lever Cable Adjustment in this article. TEST the system for normal operation.