LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 889 (Climate Control) >> Removal And Installation >> Blower Motor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the speed control actuator electrical connector.
  2. Remove the speed control actuator bolt and position the speed control actuator aside.
    • To install, tighten to 11 Nm (8 lb-ft).
  3. Disconnect the blower motor electrical connector.
  4. Remove the blower motor vent tube.
  5. Remove the 4 blower motor screws and the blower motor.
  6. Remove the blower motor wheel clip.
  7. Remove the blower motor wheel.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals