LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 886 (Engine Cooling System) >> Removal And Installation >> Radiator - 3.0L, 4.0L >> Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the radiator and install the 2 bolts.
    • Tighten to 7 Nm (62 lb-in).


  1. Connect the lower radiator hose to the radiator.
  2. Connect the upper radiator hose to the radiator.
  3. Install the cooling fan shroud. For additional information, refer to Cooling Fan Shroud - 3.0L, 4.0L  in this article.
  4. Connect the radiator overflow hose to the radiator.
  5. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding - 3.0L, 4.0L  in this article.
    6. WARNING: Do not stand in line with or near the engine cooling fan blade when revving the engine. A damaged fan can separate during operation. Failure to follow this instruction may result in serious personal injury.
  6. Operate the engine for several minutes and check the hoses and connections for leaks.
scientia non olet · About LEMON Manuals