Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
- Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding - 2.3L in this article.
- Remove the drive belt. For additional information, refer to ACCESSORY DRIVE article.
- Remove the bolts and the coolant pump pulley.
- To install, tighten to 20 Nm (15 lb-ft).
- Remove the bolts and the coolant pump.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
NOTE:
Lubricate the coolant pump O-ring seal with clean coolant.