Backlash within specification

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the 4 bolts and the 2 bearing caps.

Fig 1: Identifying Differential Bearing Shim Sizes

Courtesy of FORD MOTOR CO.

To establish differential bearing preload, increase both left and right differential bearing shim sizes by the specification shown.

Fig 2: Seating Differential Bearing Shims Using Special Tool

Courtesy of FORD MOTOR CO.

Using the special tool, fully seat the differential bearing shims. Make sure the assembly rotates freely.

Fig 3: Identifying Differential Bearing Cap And Differential Bearing Cap Bolts

Courtesy of FORD MOTOR CO.

Install the 2 bearing caps and 4 bolts.
- Tighten to 112 Nm (83 lb-ft).

Fig 4: Measuring Ring Gear Backlash

Courtesy of FORD MOTOR CO.

Using the special tools, recheck the backlash.
Install the axle shafts. For additional information, refer to Axle Shaft .