Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The window must be in the raised position.

Remove the exterior door handle. For additional information, refer to Exterior Rear Door Handle - Crew Cab .

Fig 1: Lock Linkage Guide Clip

Courtesy of FORD MOTOR CO.

Release the lock linkage guide clip from the rear door.
Release the clip and disconnect the door lock actuating rod from the latch.

Fig 2: Clip

Courtesy of FORD MOTOR CO.

Release the clip.
Remove the 3 screws and position the rear door latch aside.
- To install, tighten to 12 Nm (9 lb-ft).

Fig 3: Actuating Cable And Conduit

Courtesy of FORD MOTOR CO.

Remove the rear door latch actuating cable water seal.
Disconnect the actuating cable and conduit.
Disconnect the 2 electrical connectors and remove the rear door latch.
To install, reverse the removal procedure.