All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the door trim panel and watershield. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
Loosen the glass clamp nuts.
- Temporarily install the window switch or window regulator handle, and lower the window to access the glass bracket nuts.
- To install, tighten to 13 Nm (10 lb-ft).
Fig 1: Locating Glass Clamp Nuts
Courtesy of FORD MOTOR CO.
Remove the inner and outer beltline weatherstrips.

Fig 2: Identifying Inner And Outer Beltline Weatherstrips
Courtesy of FORD MOTOR CO.
Loosen the rear glass run bolt.
- To install, tighten to 13 Nm (10 lb-ft).
Fig 3: Locating Rear Glass Run Bolt
Courtesy of FORD MOTOR CO.
Remove the rear door window glass from the regulator channel by sliding the channel forward, then position the rear door window glass in the bottom of the door.
Remove the window glass.
- Remove the front edge of the window glass from the glass run.
- Lift the window glass up through the beltline weatherstrip opening to remove from the door.
To install, reverse the removal procedure.