All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front door trim panel, interior sail cover and watershield.
Remove the exterior mirror. For additional information, refer to REAR VIEW MIRRORS article.
Temporarily install the window switch or the window crank and lower the window to access the glass bracket nuts and remove the nuts.
Remove the inner and outer beltline weatherstrips.

Fig 1: Removing Inner And Outer Beltline Weatherstrips
Courtesy of FORD MOTOR CO.
Loosen the rear glass run bolt.
- To install, tighten to 13 Nm (10 lb-ft).
Fig 2: Identifying Rear Glass Run Bolt
Courtesy of FORD MOTOR CO.
Remove the front door window glass from the channel by sliding the channel forward, then position the door glass in the bottom of the door.
Remove the window glass from the inner door by tilting the window glass forward and lifting the glass out of the door.

NOTE: Make sure the door glass is seated in the glass run channel and the rear glass run bolt is positioned all the way forward prior to tightening the rear glass run bolt.

To install, reverse the removal procedure.