LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Intake Manifold Runner Control (IMRC) Actuator - 4.2L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper intake manifold. For additional information, refer to ENGINE - 4.2L article.
  2. Disconnect the intake manifold runner control (IMRC) electrical connector.
  3. Disconnect the IMRC actuator rods.
  4. Remove the bolts and the IMRC actuator.
    • To install, tighten to 10 Nm (89 lb-in).
  5. Inspect the IMRL actuator rod retainers. Install new retainers if damaged.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals