Removal and Installation

Front 

NOTE: Do not pull down on the front of the overhead console.
1. Pull down on the rear of the overhead console to remove the overhead console from the retaining clips.
   • Disconnect the electrical connectors.
2. Release the 4 retaining clips and remove the lamp assembly from the overhead console.
   Fig 1: Locating Lamp Assembly Retaining Clips

   Courtesy of FORD MOTOR CO.
3. Release the 6 retaining clips and remove the lens from the lamp assembly.
   NOTE: The bulbs can be pushed out from the backside of the lamp assembly.
   Fig 2: Locating Retaining Clips
   Courtesy of FORD MOTOR CO.
   • Replace the bulb(s) as necessary.

   Rear 

4. Remove the interior lamp lens.
   Fig 3: Locating Interior Lamp Lens

   Courtesy of FORD MOTOR CO.
5. Release the 2 retaining clips (through the access holes) and remove the interior lamp.
   • Disconnect the electrical connector.
     Fig 4: Locating Interior Lamp Retaining Clips

     Courtesy of FORD MOTOR CO.

   Any interior lamps 

6. To install, reverse the removal procedure.